Ceiling Tiles
Deep Drop Panels
3/4" deep, Drop-In Ceiling Panels. These panels install exactly like the regular drop-in panels, except they give you a three dimensional look. Deep-Drop tiles weigh approx. 1.85 lbs. each.
Instructions.Things You'll Need:

Drop tile ceiling hardware, which includes screws, suspension wires and cross tees
Sharp knife
Chalk box or laser
Tin snips
Drill with eye bolt driver

1. Establish the correct height for the ceiling with a laser level or chalk box.

2. Fasten the outer trim pieces to the wall with screws. The screws should be long enough to go through the wall and into the wall studs.

3. Hang the suspension wires from the ceiling. Depending on the ceiling and the installer's preference, the hanger wires can be attached using different types of screws or bolts made for drop ceiling applications, or by wrapping the grid hangers around the joist or other stationary objects. The spacing intervals between the hanger wires is commonly 48 inches throughout the entire ceiling, and should hang a foot lower than the ceiling height.

4. Hang the main runners of the metal grid using the hanger wires to tie the grid in place. The main runners will run from one side of the wall to the other; they will snap into the trimming that runs along the wall. The runners will have pre-drilled holes that the grid hangers will slip through and tie. The direction of the main runners should run at right angles to the joist when installed. To make sure that the metal runners are level, use a laser to site the grid, or stretch out a string from wall trim to opposite wall trim.

5. Install the cross tees between the main runners and secure them into position using the tabs at the ends of the cross tees, which engage in the slots of the runners. The typical ceiling tile will be either 2-by-2-foot or 2-by-4-foot.

6. Place the ceiling tiles in the grid flanges. Cut the tiles by scoring them with a sharp knife and then snapping them. For radius cuts, use a jigsaw or compass saw to cut the tiles.

2' x 2' cross tees for Suspended Ceilings. Change your 2' x 4' opening to a 2' x 2' opening to accomodate 2' x 2' Tin Ceiling Panels.
Now Available!!!!!

Cost: $2.00 each!
mals_tin_website062005.jpg mals_tin_website062004.jpg
Any steel material should be coated with an oil-based product
for protection and best results.

If you choose to paint your metal ceiling, be sure you use an oil-based primer and paint as the steel will rust if a water based product is used. Unfinished steel must be cleaned with wax and grease cleaner before painting. Use care not to scratch pre-painted finishes when nailing up ceiling.
Made in the USA
Review Cart


Cost Estimator
Nail-ups Install
Backsplash Install
Crown Install
Deep Drop Install
Drop-Ins Install
New Products
Buy Samples
Cone Head Nails, Dropin Tile Clips
Tiles & Products
Color Choices
New Snap-Grid
About Us
Our Blog
Call Us: