Standard Drop-in tin ceiling panels fit all standard 15/16" 2'x2' grids. Overall Dimensions: 23-3/4" x 23-3/4"
Face Dimensions: 22-7/8" x 22-7/8", Drop-In tiles weigh approx. 1.85 lbs each.
Instructions.Things You'll Need:
Drop tile ceiling hardware, which includes screws, suspension wires and cross tees
Chalk box or laser
Drill with eye bolt driver
1. Establish the correct height for the ceiling with a laser level or chalk box.
2. Fasten the outer trim pieces to the wall with screws. The screws should be long enough to go through the wall and into the wall studs.
3. Hang the suspension wires from the ceiling. Depending on the ceiling and the installer's preference, the hanger wires can be attached using different types of screws or bolts made for drop ceiling applications, or by wrapping the grid hangers around the joist or other stationary objects. The spacing intervals between the hanger wires is commonly 48 inches throughout the entire ceiling, and should hang a foot lower than the ceiling height.
4. Hang the main runners of the metal grid using the hanger wires to tie the grid in place. The main runners will run from one side of the wall to the other; they will snap into the trimming that runs along the wall. The runners will have pre-drilled holes that the grid hangers will slip through and tie. The direction of the main runners should run at right angles to the joist when installed. To make sure that the metal runners are level, use a laser to site the grid, or stretch out a string from wall trim to opposite wall trim.
5. Install the cross tees between the main runners and secure them into position using the tabs at the ends of the cross tees, which engage in the slots of the runners. The typical ceiling tile will be either 2-by-2-foot or 2-by-4-foot.
6. Place the ceiling tiles in the grid flanges. Cut the tiles by scoring them with a sharp knife and then snapping them. For radius cuts, use a jigsaw or compass saw to cut the tiles.
7. Install "Hold Down Clips" if necessary to keep your tiles laying flat in the ceiling grid system. Sold seperately!
- Protecting Unfinished Material
Any steel material should be coated with an oil-based product
for protection and best results.
If you choose to paint your metal ceiling, be sure you use an oil-based primer and paint as the steel will rust if a water based product is used. Unfinished steel must be cleaned with wax and grease cleaner before painting. Use care not to scratch pre-painted finishes when nailing up ceiling.
Hold Down Clips
Color matched 15/16" T-grid. 60 Colors to choose from.
2' x 2' cross tees for Suspended Ceilings. Change your 2' x 4' opening to a 2' x 2' opening to accomodate 2' x 2' Tin Ceiling Panels.
Cost: $2.00 each!
Made in the USA